Metal Roofing Services in Buffalo, NY

It depends on the size and pitch of your roof, the panel type, and how much tear-off and deck repair the job needs. As a rough guide, metal roofing in the Buffalo area runs about $9 to $24 per square foot installed, with standing seam at the higher end. Plan on it costing roughly two to three times what an architectural shingle roof costs. We give free written estimates, and financing is available.

For most homeowners who plan to stay put, yes. Metal sheds snow, resists wind uplift, and doesn’t break down through freeze-thaw cycles the way asphalt shingles do. If you’ll be in your home 15 years or more, the longer lifespan usually makes up for the higher upfront price. If you’re selling in the next few years, shingles may be the smarter spend. Still weighing materials? Read our guide to the top roof replacement options for Buffalo homeowners.

It can, which is why snow guards matter. Snow on a metal roof tends to let go in sheets once it starts to warm up. We install snow guards over entry doors, walkways, driveways, decks, gas meters, and lower roofs so snow comes off gradually or stays put until it melts. On tight city lots, we plan for your neighbor’s side too.

It helps a lot, but it isn’t a cure-all. Snow slides off before it can pile up at the eaves, so there’s less meltwater to refreeze. Ice dams still start with heat escaping into your attic, so we check your ventilation and install ice and water barrier along the eaves, which is required by code in our area. Dealing with ice dams right now? See our ice dam removal service.

Not on a house. A residential metal roof goes over a solid roof deck and underlayment, with your attic insulation underneath. Most homeowners tell us it sounds about the same as shingles. That loud tin-roof sound comes from panels screwed straight to open framing on barns and sheds.

Code allows it in some cases when there’s only one layer of shingles. In Buffalo, we usually recommend a full tear-off anyway. It lets us check the deck for rot, install ice and water barrier at the eaves, and give the panels a flat, solid surface. Plenty of older homes here already have two or three layers, and those have to come off regardless.

Standing seam is the top pick for most homes here. The fasteners are hidden under raised seams, so there are no exposed screws to loosen or leak over time, and snow slides off clean. Exposed-fastener panels cost less and work well on garages, porches, and outbuildings. Metal shingles and stone-coated steel give you the look of shingles, slate, or shake with the durability of metal.

A properly installed steel or aluminum roof typically lasts 40 to 70 years. Many painted panels carry manufacturer finish warranties of 30 years or more. Architectural shingles, by comparison, usually last around 20 to 30 years.

Most homes take 2 to 5 days, depending on size, pitch, tear-off, and weather. Metal takes a little longer than shingles because panels and trim are measured and formed to fit your roof. You’ll get a timeline with your estimate.

Yes, on dry days. Metal panels don’t rely on adhesive strips that need warm temperatures to seal the way shingles do. We schedule around lake-effect bands and icy mornings, so a winter job can run a day or two longer.

A full roof replacement generally requires a building permit, and we take care of it. If your home is a designated landmark or sits in a City of Buffalo preservation district, like Allentown or Linwood, exterior changes go through the Buffalo Preservation Board. Switching from shingles or slate to metal may need approval, so we check before we quote.

Yes. Standing seam is one of the best roofs for solar. Panels clamp directly to the seams, so nothing gets drilled through your roof. And because the metal roof will outlast the solar system, you won’t have to pull the panels off to re-roof down the road.

No. A metal roof doesn’t make your home more likely to get struck. If lightning does hit, metal won’t burn the way combustible roofing materials can.

It can look great. Panels come in dozens of colors, from charcoal and matte black to barn red, forest green, and bronze, and metal shingles can mimic slate or cedar shake. We’ll help you pick a profile and color that suits your house, whether it’s a Victorian in Allentown or a Cape Cod in Cheektowaga.